Selve Commeo/iveo SE Plus-RC Notice De Réglage page 35

Safety instructions
• Check the system at regular intervals for a lack of balance or for signs
of wear or damaged springs and connection cables. It must not be
used if repairs or corrections are required. Check the motor and the
complete installation for damage. In case of damage to the motor,
in particular to the connection line, it must not be taken into opera-
tion!
• The motor is only working when installed and must only be con-
nected when powered down. The motor must only be connected
to the powered part with adapters and couplings from the current
SELVE catalogue. The smallest shaft diameter for SELVE motors for
series 1 (e.g. SE.. 1/...) is 40 mm, for series 2 (e.g. SE.. 2/...) 50 mm
and for series 3 (e.g. SE.. 3/...) 60 mm. For grooved tubes, there may
be an eccentric design for the coupling and adapter.
• Nominal torque and duration of activation must be aligned with the
system requirements. Technical data such as nominal torque and
duration of activation are written on the identification plate.
• If a motor is used in an awning, the awning must not be operated
while work such as maintenance or window cleaning is carried out
nearby. For automatically controlled awnings, the awning must be
disconnected from the power for the above work.
• The motor may be used by children aged 8 or over and by people
with reduced physical, sensory or mental abilities or with a lack
of experience and knowledge if they are supervised or have been
trained in how to use the device safely and they understand the
risks involved.
• Keep objects from the operating area. It must be possible to see the
operation area during working process. Observe the system while
it is operating and keep other people away from it. Use only locked
switching elements.
35
EN