Selve Commeo/iveo SE Plus-RC Notice De Réglage page 54

commeo initial operation/setting by radio
Note for settings under point 5.2.: The motor must be selected for this setting with a trans-
mitter in SELECT mode (Status LED flashes slowly in orange). After completing the setting,
the motor is still selected (see point 5.).
5.2.4. Programming/deleting transmitters
To program or deprogram a transmitter, select the desired channel and push the PROG but-
ton for 1 second. The status LED lights up green to indicate that the transmitter has been pro-
grammed. A red light means that the transmitter has been deprogrammed.
1 s
5.2.5. Delete transmitter table in the receiver
To delete the transmitter table in the receiver, push the PROG button on the transmitter for
6 seconds. All transmitters programmed in the receiver are deleted. The receiver is still pro-
grammed in the transmitter. The programmed receiver has been cancelled in the transmitter.
Note: This causes an error message if there are any more programmed receivers!
If this receiver in operating mode moves over a transmitter which is still pro-
grammed, the transmitter will no longer receive a response and will acknowledge
this with an error message.
6 s
5.2.6. Reset the receiver to the factory setting
To reset a receiver to factory settings, push the PROG button on the transmitter for 9 seconds.
All settings are reset to factory settings. There are no transmitters and end positions saved in
the motor anymore! The programmed receiver has been cancelled in the transmitter.
Note: This causes an error message if there are any more programmed receivers!
If this receiver in operating mode moves over a transmitter which is still pro-
grammed, the transmitter will no longer receive a response and will acknowledge
this with an error message.
9 s
5.2.7. CONFIGURATION mode (only for authorised qualified personnel)
In configuration mode, you can set the functions of the radio drives and receivers. The
functions that can be set depend on the type of drive/receiver. You can find more detailed
information on configuration mode in the document "Configuring radio drives and receivers",
which is available to download www.selve.de
Status LED transmitter = green transmitter programmed
Status LED transmitter = red transmitter deleted
54