Selve Commeo/iveo SE Plus-RC Notice De Réglage page 59

iveo initial operation/setting by radio
6.2. Programming transmitters/channels
6.2.1. Programming further transmitters/channels
Press the PROG button of a programmed transmitter/channel for 3 seconds (wait for confir-
mation run from the motor). The receiver is now in programme mode for 1 minute. Press
(1 sec.) the PROG button of the new transmitter/channel. The new transmitter/channel has
now been programmed.
Programmed
transmitter/channel
3 s
6.2.2. Deleting of transmitters/channels
Press the PROG button of a programmed transmitter/channel for 3 seconds (wait for confir-
mation run from the motor). The receiver is now in programme mode for 1 minute. Press
(1 sec.) the PROG button of the transmitter/channel you wish to delete. The transmitter/
channel has now been deleted.
Programmed
transmitter/channel
3 s
6.3. Intermediate positions
For setting and calling the intermediate positions, see the transmitter instructions.
6.4. Functions in service mode (setting by using a transmitter)
In order to carry out the following settings, the motor has to be put into service mode by dis-
connecting it from the mains supply in a special way.
Consider the following:
• Transmitter programmation has to be finished before service mode can be exe cuted.
• Put only the motor which is to be set into service mode.
• The motor remains in service mode for 4 minutes.
• In order to leave the service mode just drive the motor up or down.
Fuse/Hirschmann plug
3 s 3 s
The motor confirms the service mode by a brief up and down moving.
New
transmitter/channel
1 s
Transmitter/channel
to be deleted
1 s
3 s
59
EN