Selve Commeo/iveo SE Plus-RC Notice De Réglage page 47

Setting of the end positions
4.5.3. Manual setup-mode, deletion and manual setting of the end positions
in operation bottom position, top stop
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored. Drive against the top stop until the motor is auto-
matically switched off.
Setting with Drive
setting switch
E
6 s
E STOP
E
3 s
E STOP
3 s
E
3 s
Press the E button of the setting switch for 6 seconds. The
motor will switch to manual setting mode. Both limit positions
already set will be deleted.
Move the motor to the lower end position with the UP or
DOWN button.
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out at
the end of the end position setting.
Move the motor to the designated upper end position.
Press the E button for 3 seconds. The end positions are now set
and the rotation direction assignment is correct. Perform a test
run.
47
EN