Selve Commeo/iveo SE Plus-RC Notice De Réglage page 43

Installation and electrical connection
4. Setting of the end positions
4.1. Delivery status
In the SELVE delivery status no end positions or transmitters are programmed into the radio
motor! In this state, the motor can be operated in deadman's operation only. Safety functions
are deactivated at delivery and will only become active after both end positions are set.
In delivery status the SE Plus-RC is in semi-automatic programming mode. This will be signal-
ized by a short up and down movement when connected to mains.
4.2. Setup functions
The end positions setting of a SELVE radio motor is possible via:
• the setting switch for radio motors (item no. 290109 or 291009) or with
• any standard switch (only in semi-automatic mode) or with
• any standard commeo or iveo transmitter.
4.3. Mechanic requirements
The operation of the SE Plus-RC as roller shutter motor is possible by using safety springs or
blocking springs. When using the SE Plus-RC as awning motor the awning fabric will often be
connected directly with the fabric shaft.
Caution: There is no automatic setting of the lower end limit when using the SE Plus-RC. The
lower end limit has always to be run-up to or also set.
Caution: When setting in semi-automatic and manual setting mode, a fixed upper end limit
has to exist if this end limit has to be recognized from the motor automatically.
4.4. Selection table for settings
Setup-mode/end positions in operation
Semi-automatic setup-mode
bottom position, top stop/release*
Manual setup-mode
bottom position, top stop/release*
Manual setup-mode
bottom position, top position
* Both setting procedures are leading to the same result: bottom position: point, top posi-
tion: limit stop/relief
Setting switch commeo radio iveo radio
4.5.1. 5.2.1.
(page 45) (page 51)
4.5.2. 5.2.2.
(page 46) (page 52)
4.5.3. 5.2.3.
(page 47) (page 53)
43
6.1.1.
(page 56)
6.1.2.
(page 57)
EN
6.1.3.
(page 58)