Numatic NX 300 Traduction Du Manuel D'utilisation D'origine page 31

EN
Raising/Lowering the Floor Tool
After preparing the floor (see previous section), we
are now ready to set the controls to suit the cleaning
conditions.
Before any settings can be applied, ensure the brush
deck is lowered. Move the floor tool lever to its
lower position.
Note: Do not pull the machine backwards with
the floor tool in the lowered position, this could
possibly damage the blades.
Raising/Lowering the Brush Deck
Setting the Cleaning Controls
Trigger
To check the battery level pull one of the Triggers
or press button (A).
To tip the deck into the down position (Operating mode). Press in the brush
deck locking pin (Fig.A)
and rotate the brush deck (Fig.B & C). To change to brush deck up position,
(Transit mode) simply lift the deck and the spring loaded locking pin will
activate to hold the deck up.
A
A
On / Off
+
Trigger
Machine Operation
B
-
B
Adjust water flow using the fluid control tap (B).
31
31
C