Télécharger Imprimer la page

Numatic NX 300 Traduction Du Manuel D'utilisation D'origine page 21

Publicité

EN
Fitting the Hose Guide
Refit vacuum hose to the
Floor tool when finished.
Filling the Clean Water Tank
A
To fill the clean-water tank, use the FLEXI - FILL pipe from either a tap or hose pipe.
(Fig.A & B).
The large cap can also be used for filling from a bucket or suitable container. (Fig.C).
Fill the clean-water tank to MAX line indication on tank, including cleaning chemicals if
required. Follow chemical manufacturing guide lines.
The clear dump hose at the rear of the machine can be used to see the level of the
clean-water. (Fig.D).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt,
etc.) are not allowed to enter the clean water tank during the filling process. If
using a bucket or similar, ensure it is always clean and free from debris.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical recommended for use in auto
scrubber dryers, dilute to the manufacturers specification. For further guidance on
hazardous substances refer to health and safety instructions online.
!
WHEN HANDLING AND MIXING CHEMICALS
Always ensure that chemical manufacturer's
safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
Machine Set-up Guide
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water
spillage when the vacuum is switched off. If you need to remove the U-bend clip for any
reason always ensure it is refitted correctly before you resume operation.
B
21
21
Note: DO NOT push the vacuum hose
onto the floor tool with the floor tool in
the raised position.
C
!
D
D

Publicité

loading

Ce manuel est également adapté pour:

Ttb3045nxTtb3045nx-r