Assembling The Pump Set - Medela Swing Flex Mode D'emploi

7. Preparing for pumping
Caution
18 18
l Wash hands thoroughly (at least one
minute) with soap and water before
touching the breast and pump parts.
Dry your hands with a fresh towel
or a single-use paper towel.
l Also, bottles and component parts
may become damaged if mishandled,
e.g. dropped, over-tightened,
or knocked over.
l Take appropriate care in handling
bottles and componets.
Note
l Use Medela original accessories only.
l Hold the tubing by the connecting
piece while attaching and detaching
it.
l All components must be completely
dry before use.
i
Info
l Carry out all the steps with care and
assemble the pump set correctly.
Otherwise a good vacuum may not
be achieved.

7.3 Assembling the pump set

1
Check pump set components for
wear or damage before use and
replace if necessary.
Make sure parts are cleaned
according to chapter 6 before
assembling the pump set.
Carefully place the membrane
into the connector with the flap
into the opening of the connector.
Make sure that the membrane
forms a seal around the edge
of the connector.
4
Screw bottle into connector.