Assembling The Breast Pump; Selecting The Correct Breast Shield Size; Assembling The Pump Set - Medela Swing Maxi Mode D'emploi

6. Assembling the breast pump

Only use clean and dry parts for assembly. Refer to chapter 5 for cleaning.

6.1 Selecting the correct breast shield size

Nipple
measure
Nipple base
Areola
1. For proper sizing, measure the diameter of your nipple.
2. Select the breast shield that is slightly larger than your nipple.
For more information on breast shield sizing, visit www.medela.com
or MedelaBreastShields.us (U.S.) or Medela.ca (Canada).

6.2 Assembling the pump set

Parts needed:
• Pump set
• Breast shields
• Connector bodies
• Membranes
• Bottles
101043399-2021-04-A-swing-maxi-MedelaFamily-MD-ifu-ENUS-FRCA-ESMX.indb 19 101043399-2021-04-A-swing-maxi-MedelaFamily-MD-ifu-ENUS-FRCA-ESMX.indb 19
Measure
nipple diameter
(Ø mm)
Up to 17
Breast shield size
(Ø mm) 21
To prevent contamination of your milk:
• Wash hands thoroughly with soap and water before
touching the pump unit, parts of the pump set and
breasts.
• Dry your hands with a fresh towel or a single-use paper
towel.
• Avoid touching the inside of bottles and lids.
To make sure that your breast pump works properly
and safely:
• Check pump set components for wear or damage
before use. Replace if necessary.
• Always inspect all parts prior to use for cleanliness.
If dirty, clean according to chapter 5.
• Only use genuine Medela parts. See chapter 13
for details.
Up to 26
Up to 23
Up to 20
24 27 30
• Pump unit
• Tubing
CAUTION
19
05/07/2021 12:15:25 05/07/2021 12:15:25