Assembling Your Breast Pump; Assembling The Pump Set - Medela Freestyle Flex Mode D'emploi

7. Assembling your breast pump

Only use clean and dry parts for assembly. Refer to chapter 5 for cleaning.
24

7.1 Assembling the pump set

Parts needed:
• Tubing
• Motor unit
• Breast shields
• Breast milk bottles
To make sure that your breast pump works properly and safely:
• Check pump set components for wear or damage before use. Replace if necessary.
• Always inspect all parts prior to use for cleanliness. If dirty, clean according to chapter 5.
• Only use genuine Medela parts. See chapter 14 for details.
To prevent damage to the breast pump all components must be completely dry before use.
To prevent contamination of your milk:
• Wash hands thoroughly with soap and water before
touching the motor unit, parts of the pump set and breasts.
• Dry your hands with a fresh towel or a single-use paper
towel.
• Avoid touching the inside of bottles and lids.
NOTICE
1. Carefully insert the (dark yellow) membrane with the flap
into the opening of the connector.
Æ Make sure that the membrane forms a seal around the
edge of the connector.
2. Close the lid of the connector until it audibly clicks.
• Lids
• Connectors
• Membranes
CAUTION