Troubleshooting - Medela Swing Flex Mode D'emploi

10. Troubleshooting

Problem
If the motor
is not running
If there is low
or no suction
If condensation
appears in
the tubing
The pump
becomes wet
Solution
Check presence of mains current.
Check the position of the batteries in the battery compartment.
Verify the membrane is clean and not damaged.
Ensure the membrane is attached correctly to the connector.
Check all connections.
Check the ends of the tubing fit securely into the back of the
connector and into the port on the breast pump.
Do not kink the tubing during expression.
Ensure the breast shield forms a complete seal around the breast.
Clean the tubing as described in chapter 7.5.
Shake out any water drops.
Unplug the mains adapter from the socket.
Switch off the pump.
Do not place the pump upside down. Control panel must
point upwards.
Store the pump in a dry, warm place for 24 hours.
Note:
Do not expose the pump to direct sunlight.
Do not accelerate the drying process by use of heat.
29 29