Nederman E-PAK 300 DX Manuel D'instruction page 27

All manuals and user guides at all-guides.com
out any maintenance. Keep the manual where it is always close at hand.
Replace it immediately if lost.
NOTE!
Read Chapter '4 Safety'!
This product has been designed to meet the requirements of the relevant EC
directives. To maintain this status, all installation, repair and maintenance
work is to be carried out by qualified personnel using only original Nederman
spare parts. Contact your nearest authorized distributor or Nederman for
advice on technical service or if you require help with spare parts.
Many hours have been spent on the design and production of this product in
order to make it as efficient and safe as possible. Accidents that occur despite
this are usually caused by individuals. A safety-conscious person and a well-
maintained product make a safe and effective combination.
We continuously improve our products and their efficiency through the
introduction of design modifications. We reserve the right to do this without
introducing these improvements on previously supplied products. We also
reserve the right, without previous notice, to modify data and equipment, as
well as operating and maintenance instructions.
3 Hazard notices
This document contains hazard information which must be read by all users.
The hazard information is presented as a warning, caution or note as follows:
WARNING! Type of injury.
Warnings indicate a potential hazard to the health and safety of users.
They clearly state the nature of the hazard and how to avoid it. They appear at
their points of application in this document. They look like this notice, but with
different texts.
CAUTION! Type of risk.
Cautions indicate a potential hazard to the physical integrity of the equipment,
but not a danger to personnel. They clearly state the nature of the hazard and
how to avoid it. They appear at their points of application in this document.
They look like this notice, but with different texts.
NOTE!
Notes contain other information which the user should be especially
aware of.
4 Safety
To maintain a high level of safety when using E-PAK 150 DX/300 DX/500 DX,
consider the following:
• This unit is to be installed, used and maintained according to this
document in such a way that safety is maintained. This document contains
important warning directions which have to be observed. Any functional
faults, especially those affecting the safety of the machine, are to be
rectified immediately.
• We recommend that fire alarms and appropriate extinguishing systems are
to be installed at all locations where collected combustible dust is stored.
• Standards relating to the connection and use of filters in hazardous
areas are to be taken into consideration, especially national standards
E-PAK 150 DX/300 DX/500 DX EN
27