VHF S2 Mode D'emploi D'origine page 9

WARNING
WARNING
CAUTION
CAUTION
CAUTION
Loud noise from the machine
Hearing damage due to loud noise!
Change the milling conditions. Ensure that the blanks are fixed prop-
h
erly, the condition of the tool and check the material you use.
Wear ear protection during processing, if loud noises can't be avoided.
h
Open pneumatic connections
Danger through loose pneumatic parts conducting compressed
air!
Separate the machine from the compressed air supply.
h
Consult the service department.
h
Disorder in the working environment
Trip hazard!
h Keep the working environment clean.
Store the extra equipment like the vacuum cleaner or the wet grinding
h
module in a safe place.
Ergonomics in the working environment
Subsequent damage due to constant malposition!
Adjust the working environment ergonomically.
h
Pay attention to keep the seat height, the monitor position and the
h
exposure to light ideally.
Inserting milling tools
Cuts through sharp tool cutting edges!
Grab milling tools only at the shank, not at the tool tip.
h
Take care not to cut yourself or others while handling with the tool.
h
Original Instructions: S2 Impression
Document version: F – 07/2019
General safety messages: Safety messages
9