VHF S2 Mode D'emploi D'origine page 38

Maintenance and cleaning: Calibration
b
6.6
b
38
M 5. Insert the new or cleaned filter element and reassemble the water
separator.
„
If the compressed air complies with the standard ISO 8573-1 (see chapter 4.3),
the filter element usually doesn't have to be exchanged at all. If the filter ele-
ment is polluted, please control the air purity of your compressed air.
Calibration
The machine is already calibrated on delivery. As long as your milling results
are correct, there is no need for a further calibration. If your results should
become inaccurate, a calibration could become necessary. In such a case,
please contact a service technician before recalibrating the machine.
A calibration is time consuming and can degrade your milling results in the
worst case, if it is not done correctly. Please try to change the milling con-
ditions first. Check the fixation of the blanks, the condition of the tool and
check the material you use, before you calibrate the machine.
„
Further advice for the software installation is given in the software manual.
Original Instructions: S2 Impression
Document version: F – 07/2019