VHF S2 Mode D'emploi D'origine page 27

Running the machine: Tools
The tool needs a sufficiently large chamfer at the tool shank, since the collet
NOTICE
chuck can get damaged otherwise.
A retaining ring has to be installed as a stop ring into the existing slot. Install
only retaining rings according to DIN 471-A3!
Make sure that the tools are put straight into the tool magazine. All inserted
tools must suit the positions stored in the software. Otherwise the tool
or the blanks may get damaged.
Don't use tools, where the cutting edge diameter is higher than the shank
diameter (Ø 3 mm). Don't use tools with a cutting edge diameter higher
than 2.5 mm for the tool magazine, otherwise the tool magazine inserts get
damaged.
Original Instructions: S2 Impression 27
Document version: F – 07/2019