VHF S2 Mode D'emploi D'origine page 40

Exchanging wear
parts
Exchanging the
spindle bearings
(requires spindle
exchange by service
technician)
Exchanging the tool
magazine inserts
Exchanging the
collet chuck
* These are recommendations as a guidance. Depending on the processing material and how well the
machine is cleaned, these values can differ.
6.9
40
Wear parts
Average useful life
After 2000 operating
hours* or every 2 years*
After 500 operating hours*
After 1000 operating
hours*
Inspection
vhf recommends to have a service technician perform an inspection regu-
larly. Additionally, have an inspection carried out whenever the machine is
being repaired.
Original Instructions: S2 Impression
Document version: F – 07/2019
Procedure/
Utensils
Performed by ser-
vice technician
CNC Software
(see software
manual)
–
Illustration spare part