VHF S2 Mode D'emploi D'origine page 32

Running the machine: Procedure after a power failure
Important
32
M 9. Push the gripper away from the working chamber until the end posi-
tion at the side panel.
M 10. Open the gripper.
The release carriage is in the basic position.
–
M 11. Close the working chamber door.
M 12. Activate the safety interlock of the working chamber again by turning
the key clockwise until the end position.
Make sure that the safety interlock is activated again. The machine may only
be operated when the safety interlock is activated.
M 13. Turn the machine back on again.
– The machine references and is ready for use again.
Original Instructions: S2 Impression
Document version: F – 07/2019