VHF S2 Mode D'emploi D'origine page 30

Running the machine: Procedure after a power failure
5.6
Important
Illustration 8:
30
Procedure after a power failure
If there is a short power failure while the blank changer is not in use, it is
enough to turn the machine back on again. If a power failure occurred dur-
ing processing, follow the advice of the software, so that the machine can
reference.
If there is a longer power failure or a malfunction of the power wire you can
deactivate the safety interlock with an emergency key to take the blank out
of the machine.
If the power supply is interrupted while the blank changer operates, it's not
enough just to turn the machine back on again. In this case the blank changer
produces an emergency stop signal, before the machine references. This is a
safety feature to protect the machine from getting damaged.
carriage cover
release carriage
Release carriage S2 Impression
 „
The machine had a power failure, while the blank changer was in
operation.
M 1. Turn off the machine at the main power switch and disconnect the
machine from any electrical source and the compressed air supply.
M 2. Open the blank magazine door.
Original Instructions: S2 Impression
Document version: F – 07/2019
blank holder