VHF S2 Mode D'emploi D'origine page 11

Objects
Before creating jobs, verify if the objects being prepared may be utilized at
the place of use according to local and / or national regulations or other au-
thorized organisations or entities (e. g. professional associations, health au-
thorities). In particular, verify if the material is approved for the machined
object type and if the object type is designed in accordance with applicable
regulations. Neither the manufacturing software nor the machine will inform
you about possible regulatory infringements, but will execute jobs in accord-
ance with the preferences and materials set by the user.
Verify that each object type and each material in your jobs are authorized
manufacturing materials. If mandated by local or national regulations, obtain
relevant authorization from the responsible organisation or entities (e. g. pro-
fessional associations, health authorities).
Only manufacture objects which correspond to the object types that you
can select in the import view in DentalCAM. While you can import / manu-
facture any other objects as well, neither the manufacturing software nor the
machine are designed for these other objects and should not be used in this
way.
Do not manufacture implants or parts of objects that are designed to have
contact with implants. These parts include parts of two-part abutments which
contain the connection geometry for the implant. Do not manipulate the
connection geometry of prefabricated abutments ("prefab abutments") and
you must always check finished objects for accurate connection geometries
(i.e. that connection geometries of finished jobs have not been damaged).
2.4 Transport and storage
The machine always has to be transported in an upright position.
„ „
The machine has to be transported individually at all times. Several ma-
„ „
chines may not be piled up.
For unpacking and positioning the machine two people are necessary.
„ „
Use the shell type handle on the left and on the right side beneath the
machine, to carry the machine.
Ambient temperature (storage / transport): between -20 °C and 60 °C
„ „
Relative air moisture: max. 80 %, non-condensing.
„ „
Original Instructions: S2 Impression
General safety messages: Transport and storage
Document version: F – 07/2019
11