Maintenance; Information Regarding Machine Demolition; Environmental Information - Corghi EM 9580 Manuel D'utilisation

Masquer les pouces Voir aussi pour EM 9580:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

- Repeat the wheel spin while making sure that
nothing affects machine operation while acqui-
sition is in progress.
The machine does not firmly rest on the floor.
- Make sure that the floor support is firm.
The wheel is not locked correctly.
- Tighten the locking ring nut firmly.
Several spins are to be performed to
balance the wheel
The machine was jolted during the spin.
- Repeat the wheel spin while making sure that
nothing affects machine operation while acqui-
sition is in progress.
The machine does not firmly rest on the floor.
- Make sure that the floor support is firm.
The wheel is not locked correctly.
- Tighten the locking ring nut firmly.
- Make sure that the accessories used for centring
are suitable and original.
The machine has not been calibrated correctly.
- Perform the sensitivity calibration procedure.
The entered geometric data are not correct.
- Make sure that the entered data correspond
to the wheel dimensions and correct them if
necessary.
- Carry out the external sensor calibration pro-
cedure (width).

MAINTENANCE

WARNING
the manufacturer
is not to be held responsible
for any claims deriving from the use of non-orig-
inal spare parts or accessories.
WARNING
Unplug the machine from the power supply
and make sure that all moving parts have been
locked before performing any adjustment or
maintenance operation.
Do not remove or modify any part of the machine
(except for service interventions).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of water
to remove dirt or residues from the machine.
Take all possible measures to prevent dust
EM 9580 - Operator's manual
from building up or raising during cleaning
operations.
Keep the wheel balancer shaft, the securing
ring nut, the centring cones and flange clean.
These components can be cleaned using a brush
previously dripped in environmentally friendly
solvents.
Handle cones and flanges carefully so as to avoid
accidental dropping and subsequent damage
that would affect centring accuracy.
After use, store cones and flanges in a place where
they are suitably protected from dust and dirt.
If necessary, use ethyl alcohol to clean the dis-
play panel.
Perform the calibration procedure at least once
every six months.
INFORMATION
REGARDING MACHINE
DEMOLITION
If the machine is to be scrapped, remove all
electrical, electronic, plastic and metal parts and
dispose of them separately in accordance with
current provisions as prescribed by law.
ENVIRONMENTAL
INFORMATION
The following disposal procedure shall be exclu-
sively applied to the machines having the
crossed-out bin symbol
plate.
This product may contain substances that can
be hazardous to the environment and to human
health if it is not disposed of properly.
The following information is therefore provided
to prevent the release of these substances and
to improve the use of natural resources.
Electrical and electronic equipment must never
be disposed of in the usual municipal waste but
must be separately collected for their proper
treatment.
The crossed-out bin symbol, placed on the
product and on this page, reminds the user that
the product must be disposed of properly at the
end of its life.
In this way it is possible to prevent that a non
specific treatment of the substances contained
UK
on their data
85

Publicité

Table des Matières
loading

Table des Matières