Publicité
Les langues disponibles
Les langues disponibles
7.2.4
Audible signal
7.2.4.1
General
7.2.4.2
Setting an audible signal
AB1800en
[STOP/OPEN] button twice to exit the '-> Time & Cycles'
6.
Press the
menu
or
[STOP/OPEN] button three times to exit the '*MACHINE
Press the
MENU*' .
The audible signal sounds:
■
after a problem occurs in the 2 s interval.
■
after completion of the centrifugation run and rotor standstill in the 30 s
interval.
Opening the lid or pressing any button stops the audible signal.
1.
Press and hold the
'*MACHINE MENU*' is displayed after 8 seconds.
��
[SELECT] button repeatedly until '-> Settings' is displayed.
2.
Press the
[START/PULSE] button.
3.
Press the
'End beep = on' or 'End beep = off' is displayed.
��
4.
Use the
[t] buttons to set 'off' or 'on' .
off: Audible signal after completion of the centrifugation run is disa-
bled.
on: Audible signal after completion of the centrifugation run is ena-
bled.
[SELECT] button.
5.
Press the
'Error beep = on' or 'Error beep = off' is displayed.
��
[t] buttons to set 'off' or 'on' .
6.
Use the
off: Audible signal after the occurrence of a malfunction is disabled.
on: Audible signal after the occurrence of a malfunction is enabled.
[SELECT] button.
7.
Press the
'Beep volume = min' , 'Beep volume = mid' or 'Beep volume =
��
max' is displayed.
8.
Use the
[t] buttons to set 'min' , 'mid' or 'max' .
min: The volume of the audible signal is set to low.
mid: The volume of the audible signal is set to medium.
Max: The volume of the audible signal is set to loud.
9.
Press the
[START/PULSE] button.
�� The setting is stored.
'Store Settings...' is displayed briefly.
'-> Settings' is then displayed.
10.
Press the
[STOP/OPEN] button once to exit the '-> Settings' menu
or
[STOP/OPEN] button twice to exit the '*MACHINE MENU*' .
Press the
Rev.: 09 / 01.2024
[SELECT] button.
Software operation
29 / 39
Publicité
