Hettich EBA 200 Mode D'emploi page 63

6 Operation
6.1 Opening and closing the lid
Opening the lid
Closing the lid
6.2 Removing and installing the rotor
Removing the rotor of the EBA
200
AB1800en
Personnel:
■
Trained user
The centrifuge is switched on.
The rotor is stationary.
[STOP/OPEN] button.
Press the
�� The lid unlocks by means of a motor.
'Lid unlocked' indicator appears.
The
CAUTION
Crushing hazard when closing the lid.
Danger of fingers getting crushed when the closing motor
pulls the lid against the seal.
−
No parts of the operator's body should be in the hazard
zone of the lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
−
Close the lid slowly.
−
Do not slam the lid.
Personnel:
■
Trained user
Close the lid and press the front edge of the lid down gently.
�� The lid locks using a motor.
'Lid locked' indicator appears.
The
The rotor of the EBA 200 S must only be installed and
removed by customer service.
Personnel:
■
Trained user
Rev.: 09 / 01.2024
Operation
19 / 39