Hettich EBA 200 Mode D'emploi page 71

7.2 Machine Menu
7.2.1 Querying system information
7.2.2 Cycle counter
AB1800en
The following system information can be queried:
■
Centrifuge model
■
Centrifuge program version
■
Centrifuge type number
■
Date of manufacture of the centrifuge
■
Centrifuge serial number
■
Frequency converter type
■
Program version for the frequency inverter
The rotor is stationary.
1. Press and hold the
'*MACHINE MENU*' is displayed after 8 seconds.
��
2. Press the [SELECT] button.
'-> Info' is displayed.
[START/PULSE] button.
3. Press the
�� The centrifuge model is displayed.
[SELECT] button.
4. Press the
�� The centrifuge program version
[SELECT] button.
5. Press the
�� The centrifuge type number
[SELECT] button.
6. Press the
�� The continuation of the centrifuge type number
played.
[SELECT] button.
7. Press the
�� The date of manufacture
[SELECT] button.
8. Press the
�� The centrifuge serial number
[SELECT] button.
9. Press the
�� The type of frequency converter
played.
[SELECT] button.
10. Press the
�� The program version of the frequency converter
centrifuge is displayed.
[STOP/OPEN] button twice to exit the '-> Info' menu
11. Press the
or
[STOP/OPEN] button three times to exit the '*MACHINE
Press the
MENU*' .
The cycle counter is switched off for the EBA 200 S
because there is no set limit for the rotor's period of use.
Rev.: 09 / 01.2024
[SELECT] button.
'CP FW=' is displayed.
'Type#1:' is displayed.
'Date:' of the centrifuge is displayed.
'Serial#:' is displayed.
'FC type' of the centrifuge is dis-
Software operation
'Type#2:' is dis-
'FC FW=' of the
27 / 39