Publicité
Les langues disponibles
Les langues disponibles
Operation
6.4
Centrifugation
6.4.1
Centrifugation in continuous operation
6.4.2
Centrifugation with time preselection
6.4.3
Short-time centrifugation
22 / 39
Personnel:
■
Trained user
1.
If required: Press the
�� The parameter RCF (
[RCF] button to toggle between the two parameters.
the
2.
Enter the desired speed (RPM) or relative centrifugal force (RCF).
3.
Set the parameters t/min and t/sec to zero.
'--:--' is displayed.
��
[START/PULSE] button.
4.
Press the
�� The centrifugation run is started.
The timing starts at
The rotor speed or the resulting RCF value and the elapsed time
are displayed during the centrifugation run.
[STOP/OPEN] button to cancel the centrifugation run.
5.
Press the
�� Ramp-down takes place with the set brake level. The brake level is
displayed.
When the rotor is at a standstill, the lid opens, an audible signal
sounds and the remaining number of run cycles (centrifugation
runs) is displayed.
Personnel:
■
Trained user
1.
If required: Press the
�� The parameter RCF (
[RCF] button to toggle between the two parameters.
the
2.
Enter the desired speed (RPM) or relative centrifugal force (RCF).
3.
Set the parameters t/min and t/sec to the desired value.
4.
Press the
[START/PULSE] button.
�� The centrifugation run is started.
The rotor speed or the resulting RCF value and the remaining time
are displayed during the centrifugation run.
[STOP/OPEN] button to cancel the centrifugation run.
5.
Press the
or
Wait for the centrifugation time to elapse.
�� Ramp-down takes place with the set brake level. The brake level is
displayed.
When the rotor is at a standstill, the lid opens, an audible signal
sounds and the remaining number of run cycles (centrifugation
runs) is displayed.
Personnel:
■
Trained user
Rev.: 09 / 01.2024
[RCF] button.
'>RCF<' ) or RPM ( 'RPM' ) is displayed. Press
'0:00' .
[RCF] button.
'>RCF<' ) or RPM ( 'RPM' ) is displayed. Press
AB1800en
Publicité
