Keysight E36731A Manuel D'instructions page 94

Step 1– Add/remove steps to/from the List
Press Sequencer to access the Sequencer List window.
Power Supply mode
Press Add to insert a new step below the selected step. Note that the values in the new step are copied from the
previous step. Continue to add steps until your sequence is complete. Use the navigation keys to move through the
list.
Press Delete if you want to delete the selected step. Press and hold Delete if you want to remove all steps from the
list.
Step 2 – Configure the output sequence
Configure the output sequence parameter accordingly. Use the navigation keys to select the field; use the numeric
entry keys to enter the value. The value is set when you press [Enter].
In Load mode, when switching between operating modes, the load input parameter will change accordingly. For
example, switching to CP mode will change the existing Current field to Power.
Power Supply mode
94
Load mode
Load mode
Keysight E36731A User's Guide