Front Panel Menu Reference
This is an overview of the front-panel menus. Press the softkeys to access the front panel menus.
Menu heading
Function
When function is set to Power Supply mode:
Source Settings >
Sense
Out Pref
Protection >
Voltage Slew>
When function is set to Load mode:
Load Settings >
Mode >
Sense
Protection >
Range >
Short
Common menu for both Power Supply and Load mode
Output Settings > or Input Settings>
On/Off Coupling >
Output Inhibit >
Sequencer >
Sequencer >
Utilities >
Store / Recall >
I/O Config >
Test/Setup >
Error >
Manage Files >
Lock | Unlock
* Applicable for Load mode only
Keysight E36731A User's Guide
Description
Switches the instrument function to Power Supply mode (P.Supply) or Load mode (Load).
Configures the output sense to 2-wire or 4-wire.
Configures the preferred mode for output on/off transitions.
Configures the protection setting for the output.
Configures the voltage slew rate.
Configures the operating mode to CC, CV, CR, or CP.
Configures the input sense to 2-wire or 4-wire.
Configures the protection setting for the load input.
Configures the measurement range for the load input.
Enable or disable the input short.
Enables or disables the output coupling or synchronization between multiple output channels.
Configures the inhibit input mode and Digital IO Pin 3.
Configures the sequencer type: LIST, Continuous*, Pulse*, and Toggle*.
Saves and recalls instrument states.
Displays and configures the I/O parameters for remote operations over the USB, LAN, GPIB, or digital
IO interface.
Accesses the self-test, calibration, and help function as well as configures the user preferences, and
sets date and time.
Displays the instrument's error queue. Errors will be cleared after viewing or instrument reset.
Creates, copies, deletes, and renames files and folders on the USB drive attached to the front panel.
Also allows you to capture the current screen to either a bitmap (*.bmp) or portable network graphics
(*.png) file.
Locks and unlocks the display.
61