Keysight E36731A Manuel D'instructions page 46

Installing the optional GPIB interface
TURN OFF POWER AND REMOVE ALL CONNECTIONS PRIOR TO INSTALLATION
Turn off the power and remove all connections, including the power cord, from the instrument prior installation
of the GPIB interface.
RETAIN GPIB COVER PLATE
After installing the GPIB option, retain the cover plate for use in the event that you ever remove the GPIB
option. The instrument should never be connected to AC mains or output terminal when the rear-panel open-
ing is not securely covered with either GPIB module or the cover plate.
The following tools are required.
– Torx screwdriver
Make sure you turn the instrument upside down before proceeding.
Use a Torx screwdriver to remove the M3 screws
from the GPIB cover plate. Retain the screws for
use later in this procedure.
Then, remove the cover plate.
Attach the cable to the connector located in the
previous step.
46
Locate the connector, just inside the unit, to connect
the cable that is attached to the GPIB module.
Put the module into the unit. Use the screws that was
removed earlier to secure the GPIB plate in place.
This concludes the GPIB installation procedure.
Keysight E36731A User's Guide