Keysight E36731A Manuel D'instructions page 104

From the remote interface:
To configure the load operating mode to CC mode:
FUNC CURR, (@1)
To set the sequencer to Toggle mode:
TRAN:MODE TOGG, (@1)
To configure the main current level with 5 A:
CURR 5, (@1)
To configure the value for the transient current level with 10 A:
CURR:TLEV 10, (@1)
To set the trigger source to Key/Immediate:
TRIG:TRAN:SOUR IMM, (@1)
To configure the input voltage to follow transient value when a trigger occurs:
CURR:MODE LIST
To enable the input channel:
INP ON, (@1)
To initiate the transient operation sequence:
INIT:TRAN, (@1)
104 Keysight E36731A User's Guide