Keysight E36731A Manuel D'instructions page 22

Data logger view
Press [Scope/Data Log] to access Data Logger view. This key toggles between Data Logger view and Scope view.
Item
1 Data bar and time elapsed
Displays the progress of the data logger. The yellow bar indicates the visible data. Numbers to the left indicate time elapsed/total
duration.
2 Data traces
Voltage, current, or power traces. Voltage traces V1 is shown. Press Auto Scale to auto scale all traces.
3 Time/Div
Indicates the horizontal time-base setting.
4 Offset time
Indicates the time that the right gridline is offset or away from the end of the data log.
5 Grid time
Displays the time on the gridline.
6 Filename
Indicates the file to which the data is being logged.
7 Status
Indicates whether the Data Logger is logging data, done logging, or is empty.
8 Trigger Source
Indicates the trigger source for the data logger.
9 Sequencer status
Indicates the Sequencer is running, or waiting for a trigger. No indicator when Sequencer is idle.
10 Trace controls
Identifies the voltage or current trace that will be displayed. Dashes (----) indicate that the specified trace is turned off. Select the
trace and press [Enter] to turn it on or off.
11 m1 marker
Measurement Marker 1 enabled. This can be adjusted using the Vertical knob after pressing Knob Mrk.
12 m2 marker
Measurement Marker 2 enabled. This can be adjusted using the Horizontal knob after pressing Knob Mrk.
13 Intersect point
Shows where the measurement markers intersect the waveform.
22
Description
Keysight E36731A User's Guide