Publicité
Les langues disponibles
Les langues disponibles
EPAC
Piuma
Piuma +
Piuma-S
Piuma-S +
Make sure that the electrically power assisted cycle is switched of and the battery is
switched of/disabled (if required by the model of battery supplied with the bike).
Make sure that the battery charger, its jack and the charging port of the battery are dry.
Connect the battery charger jack to the battery charging port and then, the mains power
socket (230V/50Hz).
There is a red indicator light when the battery is charging. When the indicator light turns
green, it signals that the battery charging cycle has been completed.
Disconnect the battery charger jack from the battery charging port and then, the mains
power socket.
CAUTION
Using a battery charger that differs from the one supplied, which is not suitable or approved,
to charge the e-bike battery may damage it or involve other potential risks.
Never leave the e-bike unsupervised while it is charging.
Do not switch on or ride the e-bike during charging.
Keep out of the reach of children during charging. Do not place anything on top of the
battery charger during use; do not allow any liquid or metal to get inside the battery charger.
The battery charger heats up during the battery charging cycle.
Do not charge the battery immediately after use. Allow the battery to cool down before
charging it.
The item should not be charging for extended periods. Overcharging reduces battery life
and poses additional potential hazards.
Battery charger INPUT
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
Battery charger OUTPUT
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
A. Battery charging jack
B. Power supply jack
C. Battery charging LED indicator light
35
Publicité
