ARGENTO E-Bike Piuma Mode D'emploi page 32

Indicator light for residual battery charge
The battery charge level is shown on the display screen as a number of dashes between 0
and 5.
If there are 5 dashes, it means that the battery is charged to the maximum percentage
defined and detected instantly.
Less dashes are shown to indicate a decrease in the battery charge level available and
subsequent autonomy.
The level of the battery charging indicator may fluctuate depending on how the electrically
power assisted cycle is being used, for example, when going up a slope, the level displayed
can drop rapidly as there is a much higher battery consumption.
The individual dashes indicate the specific battery charge range detected at the time and do
not necessarily indicated a percentage of the residual autonomy.
Malfunction indicator light
If a malfunction of the bike's electrical and/or electronic system is detected, the relevant
warning light will appear on the display screen and the corresponding identification Error
Code will be displayed at the same time.
Error Code
04
06
07
08
09
10
11
12
13
14
21
22
30
Parameter configuration
Press the M button for at least 2 seconds to access the configuration menu and then,
quickly press the M button to confirm the data entered and display the next parameter to be
configured.
Select the desired value for the individual parameter by pressing the + or - buttons and
confirm it by pressing the M button (quickly to access the next parameter or for at least 2
seconds to exit the configuration menu).
The sequence of parameters that can be configured is shown below:
S7 - Unit of measurement:
press the + or - buttons to select the unit of measurement for the speed and distance data
shown on the display:
international metric system (Km/h and Km) or British imperial system (MPH and Miles)
Malfunction description
Accelerator malfunction
Low voltage protection (voltage below threshold)
High voltage protection (voltage above threshold)
Motor hall sensor malfunction
Motor phase line malfunction
Control unit overheated
Motor over temperature
Current sensor malfunction
Battery over temperature
Motor malfunction
Speed sensor malfunction
BMS malfunction
Communication malfunction
31