Publicité
Les langues disponibles
Les langues disponibles
Switching the lights ON/OFF
Press the LIGHT button for at least 1 second to switch the front light and rear light (if
applicable) on or of.
Residual battery charge indicator
The battery charge level is shown on the display within the reference values L (Low) and H
(High) by a number of LED lights between 0 and 4.
If 4 LED lights are highlighted at the same time, it means that the battery is charged to the
maximum percentage set and detected at the time.
The reduction in the number of LED lights simultaneously highlighted indicates that the
available battery charge and consequent autonomy is decreasing.
The level of the battery charging indicator may fluctuate depending on how the electrically
power assisted cycle is being used, for example, when going up a slope, the level displayed
can drop rapidly as there is a much higher battery consumption.
The individual indicator lights give an indication of the specific battery charge range
detected at the time and do not necessarily represent a percentage of the residual
autonomy.
LCD display - CDC13-BT
•
Overview of controls and symbols
1. Indicator light for light ON
2. Assist: indicator of the assisted pedalling
level selected (number)
3. Error: malfunction warning light
4. Indicator light for walk assist mode ON
5. Digital speedometer: indicator light for
speed detected during use (Km/H or MPH)
6. AVG: display of average speed data
recorded during last use (Km/h or MPH)
7. MAX: display of maximum speed data
recorded during the last use (Km/h or
MPH)
8. TRIP: display of partial distance travelled
(Km or Miles)
9. ODO: display of total distance travelled
(Km or Miles)
10. Travel mode corresponding to the selected
assisted pedalling level (ECO-STD-Turbo)
11. Indicator light for residual battery charge
12. M: mode button (MODE)
13. Button to vary and/or decrease value (-)
14. ON/OFF button
15. Button to vary and/or increase value (+)
25
Publicité
