ARGENTO E-Bike Piuma Mode D'emploi page 24

Disable the function by releasing the lever.
CAUTION
The walk assist mode must be used in compliance with the regulations in force in the
country of use and is only allowed when pushing the electrically power assisted cycle by
walking alongside the bicycle and holding the handlebar grips firmly with both hands.
DANGER
It is strictly prohibited to enable the walk assist mode when you are sitting on the saddle of
the electrically power assisted cycle to avoid the danger of injury and the risk of damaging
the electrical components of the bike.
Switching the lights ON/OFF
Press the relevant button for at least 1 second to switch the front light on or of (and rear light,
if applicable).
Residual battery charge indicator
The battery charging level is shown on the display by the number of LED lights that are
highlighted; see: 0-1-2-3-4-5.
If 5 LED lights are highlighted at the same time, it means that the battery is charged to the
maximum percentage set and detected at the time.
The reduction in the number of LED lights simultaneously highlighted indicates that the
available battery charge and consequent autonomy is decreasing.
The level of the battery charging indicator may fluctuate depending on how the electrically
power assisted cycle is being used, for example, when going up a slope, the level displayed
can drop rapidly as there is a much higher battery consumption.
The individual indicator lights give an indication of the specific battery charge range
detected at the time and do not necessarily represent a percentage of the residual
autonomy.
Malfunction indicator light
If a malfunction of the electrical and/or electronic system of the bike is detected, all the LED
lights on the display will light up and flash.
Turn of the display and then, turn it on again, identify the malfunction corresponding to the
number of flashes highlighted (flash); a table with explanations is shown below:
23