Publicité
Les langues disponibles
Les langues disponibles
17.1 Selecting the Working Mode
The device supports manual and automatic measurement (pre-sampling,
real-time sampling, periodic sampling, trigger sampling), and R-R analysis.
To select the working mode, follow the steps below:
1.
In the main screen, click [
2.
Click [ECG Setup] → [Sampling Mode] to configure the sampling
mode as needed.
3.
Return to the main screen after setting.
4.
Click the [Mode] button at the bottom of the main screen to quickly
select the desired working mode.
Caution
The working mode cannot be changed during the printing course. Stop printing
the report before changing the working mode.
17.2 Selecting the Lead Mode
The device supports 6 lead modes: 9-lead, standard 12-lead, 15-lead
(Standard + right chest), 15-lead (Standard + posterior), 15-lead (Pediatric)
and 18-lead.
To select the lead mode, follow the steps below:
1.
In the main screen, click [
2.
Click [ECG Setup] → [Lead Mode] to set the required lead mode.
3.
Return to the main screen after setting.
17.3 Setting ECG Waveform and Report
Set the ECG waveform and report before starting an ECG measurement.
Operation procedures:
1.
Click the quick keys at the bottom of the main screen to set the
speed, sensitivity, display format and filter frequency respectively.
2.
Click [Setup] → [ECG Setup] and [Record Setup] to check other
waveform setting items and report setting items, and make relevant
settings as needed.
For more information, see Chapter 8 System Settings.
Acquisition, Analysis and Printing
] → [Setup] to enter the setting screen.
] → [Setup] to enter the setting screen.
11-1
Publicité
