Publicité
Les langues disponibles
Les langues disponibles
13.7.3 Standby Mode
When there is no user operation and all leads off within the set time, the
device automatically enters the standby mode if the device is inactive for a
predefined time limit.
To set the time to automatically enter the standby mode, follow the steps
below:
1.
Click [
] button in the lower right corner of the main screen to
open the menu screen.
2.
Click the [Setup] button to enter the setting screen.
3.
Click [System Setup] → [Other Setup] → [Auto Standby].
4.
Set the time to automatically enter standby mode.
In the standby mode, the display screen is black, and the device enters the
power saving state.
To exit the standby mode, short press the Power On/Off key or click the
touchscreen.
13.7.4 Demo Mode
In this mode, the device can demonstrate its main functions when a
patient or patient simulator is not connected.
To enter the demo mode, follow the steps below:
1.
Click [
] button in the lower right corner of the main screen to
open the menu screen.
2.
Click the [Setup] button to enter the setting screen.
3.
Click [System Setup] → [Demo].
4.
Select [Normal ECG] or [Abnormal ECG].
When the demo mode is enabled, both the waveform area of the
acquisition screen and the parameter information area at the bottom left
of the printed report display the word "Demo".
To exit the demo mode, click the [Exit] button in the upper right corner of
the screen.
Warning
The Demo mode is mainly used to show the performance of the device and to
train users. In clinical use, do not set the device to Demo mode when connecting
patients, to avoid mistaking the Demo waveform for patient's waveform, which
may result in delayed diagnosis and treatment.
11-16
Publicité
