Publicité
Les langues disponibles
Les langues disponibles
14.1 Unpacking and Checking
Before unpacking, examine the packaging carefully for signs of damage. If
any damage is found, please contact the carrier immediately.
If the packaging is intact, perform unpacking inspection according to the
following steps:
1.
Open the package and take out the device and accessories carefully.
2.
Check all materials according to the packing list.
3.
Check the device for any mechanical damage.
4.
Check the accessories for scratches or defects.
Contact Carewell in case of any problems.
Warning
Keep the packaging materials out of the reach of children. When disposing of the
packaging materials, be sure to comply with your local waste control regulations
or the hospital's waste disposal system.
14.2 Selecting an Installation Location
Select a place where the infrastructure and mains supply is well set up.
Place the device in a flat operating table. The operating environment of
the device must meet the requirements specified in this manual.
Caution
Do not locate the device in a place where the power plug is difficult to plug in
and out.
14.3 Preparing the Device
If you purchased a thermal recorder base, the device preparation includes
the following steps, and each step is described in detail in the following
sections:
1.
Using the Battery
2.
Installing the Battery of Recorder Base
3.
Loading the Recording Paper
4.
Connecting the Device to the Base
5.
Connecting AC Power to the Base
6.
Connecting the Grounding Cable
Operation Preparations
11-1
Publicité
