Publicité
Les langues disponibles
Les langues disponibles
For charge time and run time of the battery, see A.3 Physical and
Hardware Specifications.
14.3.2 Installing the Battery of Recorder Base
The recorder base can be configured with a rechargeable lithium battery,
which can be charged when it is installed in the base and the base is
connected to the AC power supply.
To install the battery, follow the steps below:
1.
Gently turn the base over and use a screwdriver to remove the fixing
screws on the battery compartment cover.
2.
Plug the battery terminal into the battery connector on the base, and
insert the battery into the battery compartment.
3.
Close the battery compartment cover and tighten the fixing screws.
For charge time and run time of the battery, refer to A.3 Physical and
Hardware Specifications.
14.3.3 Loading the Recording Paper
The thermal recorder supports 210mm and 216mm width roll thermal
sensitive paper. When the recording paper is not installed or the thermal
recorder runs out of paper, the information prompt area of the device will
display "Out of Paper" to remind the user to install the recording paper.
Recording paper
To install the recording paper, follow the steps below:
1.
As shown in the figure above, push the open button on the right side
of the base and press forward slightly to open the paper
compartment cover.
2.
Take out the paper roller, insert it into the new roll paper and put the
paper with roller back into the paper compartment. Be sure to place
the movable end of the paper roller close to the open button side,
Paper compartment cover
11-3
Paper roller
Open button
Publicité
