Spengler LeECG Serie Manuel De L'utilisateur page 173

You can manually add or modify diagnosis results.
You can quickly select the diagnosis results you want by entering
keywords, because the device has loaded the diagnosis result template.
For the diagnosis that is not in the diagnosis result template, you can add
the diagnosis result, and then select it from the custom menu.
File

Click the [File] button to enter the patient archive management screen,
where you can add and modify patient information, view, query, export
and print ECG report. For more information, see Chapter 7 File
Management.
Menu Expand / Hide button

Click the [ ] button in the lower right corner of the main screen to open
the system menu. After the menu is expanded, click the [
to hide the menu.
In the expansion screen, you can quickly perform the following
operations:
Copy

Click the [Copy] button to directly print the most recently stored
report.
Setup

Click the [Setup] button to set the device comprehensively. For more
information, see Chapter 8 System Settings.
STAT

Click this button, the symbol "
click the [STAT] button before and during the acquisition process, and
click the [Cancel STAT] button to cancel the STAT ECG. After taking an
urgent/STAT ECG, the stored report in the file list is marked as "
Cal

During a manual measurement, click this button to place a 1mV
calibration square wave on each waveform on the acquisition screen
and ECG report.
Lead Switch

During a manual measurement, click this button to switch the leads
to be recorded.
Start / Stop button

" appears on the screen. You can
11-5
] button again
".