Lubrication Chart - AEBI TP48 Mode D'emploi

Lubrication chart

84
Oil changes are to be carried out in accordance with the maintenance schedule, but not less
than once a year. Always change the oil immediately after the vehicle has been used, when
the oil is warm and flows easily. Check the engine oil level only when the vehicle is standing
still, on flat and level ground, and when the engine is cold. Add oil up to the maximum mark
on the dipstick or up to the level plug. Check the hydraulic fluid only when the hydraulic link-
ages are in the lowered position.
Always grease the vehicle after steam-cleaning or -spraying.
Table of oil quantities, viscosity and quality:
1 Front axle
2 Gearbox / Hydraulics
3 Inter-axle differential
4 Rear axle
5 Engine
Grease
The following oils may be used instead of Shell Donax TD:
• Aseol Topress LS 11-910
• Motorex Polyfarm 304 or 305
• Agip Rotra THT.
API-GL 5, or MIL-L-2105 D
6.0 l or higher,
SAE90; SAE85W-90; SAE80W-90
15.0 l Shell Donax TD
API-GL 5, or MIL-L-2105 D
1.5 l or higher,
SAE90; SAE85W-90; SAE80W-90
API-GL 5, or MIL-L-2105 D
2.5 l or higher,
SAE90; SAE85W-90; SAE80W-90
API CE, SAE15W-40 or refer to engine
13.0 l
instructions manual
Multipurpose, lithium or calcium saponi-
fied