Alessi Plisse MDL09 Mode D'emploi page 20

• When the plug is inserted into
the supply socket, the ON/
OFF indicator light (E) and the
"0"position light up in red.
• Turn the knob to the right from
the ON/OFF "0" position to the
one corresponding to desired
operating speed.
• Once the speed has been selected,
the number that it corresponds to
and the indicator light will light up
in white (fig.6)
IF THE LID OR THE PITCHER IS
LIFTED DURING OPERATION,
THE SAFETY LOCK SYSTEM
STARTS WORKING, STOPS THE
BLADE ROTATION AND THE
INDICATOR LIGHT FLASHES
WHITE AND RED TO RESTART
THE BLENDER, PUT THE RAISED
PART BACK IN ITS SEAT AND
TURN THE CONTROL KNOB TO
THE ON / OFF "0" POSITION
THE INDICATOR LIGHT STOPS
FLASHING AND TURNS WHITE
INTERRUPTED WORK CAN
RESTART BY SETTING AGAIN
THE SPEED TO BE USED
ATTENTION!
WHEN OPERATED FOR THE
FIRST TIME THE BLENDER
MIGHT SMELL NEW; THIS HAS
TO BE CONSIDERED NORMAL
AND IT DISAPPEARS IN A
SHORT TIME AS IT GETS USED.
PULSE
Unless the recipe specifies otherwise,
always start at speed (1) , the lowest
setting, and then increase the speed as
necessary.
MDL09 Istruzioni.indd 20 MDL09 Istruzioni.indd 20
The (P) PULSE mode is also available,
it allows to mix intermittently. (fig. 7)
Note: The knob doesn't lock in this
position. Hold the knob or turn it
repeatedly in (P) PULSE position.
After being used, the blender shall be
turned off by bringing the knob back
to the ON/ OFF "0" position.
Only the indicator light that
corresponds to ON/OFF "0" will remain
lit and it will turn off only when the
appliance will be disconnected from
the mains.
Remove the plug from the socket
The pitcher can be removed by
simply lifting it off the motor unit.
(fig. 8)
Remove the dosage cap and the lid
and pour the processed content into
another container.
To avoid scratching the pitcher (fig.9),
use a plastic or wooden spatula to
remove the food residues.
Never use your fingers to clean the
blades.
HOW TO CARE
FOR THE BLENDER
Attention: after using it and before
any maintenance or cleaning operation
is carried out, wait for the blender to
stop, put the knob in the ON/ OFF
"0" position and take the supply plug
out of the mains socket.
• Lid with seal and dosage cap:
remove the dosage cap and the lid
from the pitcher and wash them with
washing-up liquid and warm water.
Do not wash in the dishwasher.
• Pitcher with blade unit: the fastest
and most efficient way to clean
the pitcher is to fill it halfway with
hot water (not boiling) and to add
one or two drops of washing-up
liquid. Place the pitcher on the
20
01/12/20 12:37 01/12/20 12:37