Alessi Plisse MDL09 Mode D'emploi page 18

MDL09 "Plissé" Blender
Designed by Michele De Lucchi in
2020, this blender has been tested
and certified to guarantee consumer
safety.
DESCRIPTION
OF THE BLENDER
A - Graduated dosage cap in thermo-
plastic resin (PCTG) - 30 ml capacity.
B - Lid with seal in thermoplastic
resin (PCTG).
C - Graduated pitcher in transparent
thermoplastic resin (PCTG) -
1.5 litre (48 oz – 6 cups) capacity,
with steel blade assembly.
D - Motor unit in thermoplastic resin.
E - Power indicator light.
F - Control knob.
G - Thermoplastic resin base with
non-slip feet and cable winder
compartment. (fig. 1)
The PCTG material that is used for
the dosage cap, and the graduated
pitcher is BPA free
ATTENTION!
KEEP THE APPLIANCE OUT OF
THE REACH OF CHILDREN.
THIS PRODUCT IS FOR
HOUSEHOLD USE ONLY.
• This appliance is meant for
household and similar uses
such as:
- in stores, including by non-
specialised users;
- in small businesses;
- in farmshouse;
- by clients in hotels, motels and
other residential environments;
- in bed and breakfast type
environments.
MDL09 Istruzioni.indd 18 MDL09 Istruzioni.indd 18
• Anyhow, if the appliance is to be
used professionally for preparing
food to be sold in shops, this
appliance is not to be considered
for household and similar uses.
BEFORE USING
THE BLENDER
After having taken the blender out of
its packaging, check that it is in perfect
condition.
• Remove and wash all washable
components with hot water and
washing-up liquid: dosage cap, lid
with seal and pitcher. (fig. 2)
Be careful when washing the
graduated pitcher as there are
blades inside it. Don't touch them
with the fingers because you could
cut yourself.
• To remove any dust, wipe the
motor unit ONLY with a damp
cloth (fig. 2)
HOW TO REASSEMBLE
THE BLENDER
• Fit the graduated pitcher, including
the blades, onto the motor unit
making sure that the attachment of
the safety system of the pitcher's
handle fits to the attachment on
the motor unit.
• Check that the pitcher is properly
assembled onto the motor unit
• Fit the lid onto the pitcher making
sure that the attachment of the
lid's safety system fits to the safety
system of the pitcher's handle.
Finally fit the dosage cap back on.
(fig.3)
• Check well that the lid and the
pitcher's handle are properly
assembled.
18
01/12/20 12:37 01/12/20 12:37