Alternatively, you can select an existing control panel on your network by clicking the
button. The Locate IP Device on Network window appears with a list of control panels.
Select the control panel you want to connect to and then click Ok.
•
To connect to the control panel using a dynamic IP network connection using our
ParadoxMyHome service, click the TCP-IP radio button. Then click the Site ID radio
button and enter the site ID, for example, "John's Home" . Click Ok.
A system progress window appears and displays BabyWare connection tasks. If the connection is
successful, you can open the account and begin programming the security system. Continue to
the section "Step 7: Program the Imperial system" on page 9.
If the connection is halted, see the procedure "To correct a halted connection" on page 8 of this
section.
To pre-program security settings
If you want to configure your security system before connecting to the control panel, do the
following:
1. Highlight the account you want to open by clicking the account number.
2. From the menu at the top of the window, click Open. The Main Window appears.
Figure 6 - Opening an Account
3. Follow the instructions in the section "Step 7: Program the Imperial system" on page 9. Then
follow the instructions in this section for connecting to the control panel.
To correct a halted connection
If BabyWare detects a mismatch of programmed modules to physical modules, you must manually
assign the new modules. To correct a halted connection, do the following:
1. In the System Progress window, click the Module tab. A list of devices appears.
BabyWare
8
Quick Start