Step 6: Connect To The Control Panel - Paradox MG5050 Manuel D'utilisation

Step 6: Connect to the control panel

Once you have created an account, you can connect to the control panel to begin configuring
security system parameters. Alternatively, you can pre-program security system parameters and
then connect to the control panel. Before attempting connection, be sure that the System Name
and System Password fields of the Accounts window show the correct information.
To connect to the control panel you must first verify your connection settings. This version of
BabyWare supports the following types of connection:
• Static/IP - a fixed IP network connection to the control panel
• DNS/IP - a dynamic IP network connection to the control panel
Note that this version of BabyWare does not support Serial connections to the control panel.
For more information on connecting the control panel, see the installation guide for the Paradox
IP100. This guide is located on the Paradox Web site at the following address :
http://www.paradox.com/Documentation/manuals/
archives_installationprogramming/ip100-ei02.pdf
Note that the IP100 module is already build into the Imperial control panel.
To connect to the control panel
To verify your connection settings and connect to the control panel, do the following:
1. Under the Connection Type heading, from the drop-down menu, select the appropriate
connection type. Then click the
Note that Serial connections are not supported in this version of BabyWare.
Figure 5 - Connection Settings Window
2. Do one of the following:
• To connect to the control panel using a fixed IP network connection, click the TCP-IP radio
button. Then click the IP Address radio button. Enter the IP address assigned to the
control panel and verify the port number. The default address in the control panel is
192.168.0.1. The default port number is 10000. Click Ok.
button. The connection Settings window appears.
BabyWare 7 Quick Start