Setting up the Imperial System
This section of the BabyWare Getting Started guide describes each step in the process of setting
up your Imperial system. Once you have successfully installed BabyWare, you can begin
programming security settings or home automation.
Process overview
To get started with BabyWare, you must perform the following steps:
1. Set up all hardware
2. Create control panel connection
3. Run BabyWare installation program
4. Log into BabyWare
5. Create a user account
6. Connect to the control panel
7. Program the Imperial system
Step 1: Set up all hardware
Before you can begin working with BabyWare, you must set up your security system hardware.
Refer to the installation manuals for all system components.
Step 2: Create control panel connection
For this version of BabyWare, there are two ways to a communication link between the control
panel and your PC:
•
Use an ethernet cable to connect your PC to the control panel
•
Use a wireless router to connect your PC to the control panel
If you are using a wireless router, you must first connect the control panel to your network, and
then connect your PC to the network.
For more information about configuring a wireless network connection, see the section "Step 1:
Setting up the Router" in the installation guide for the Paradox IP100. This guide is located on the
Paradox Web site at the following address :
http://www.paradox.com/Documentation/manuals/
archives_installationprogramming/ip100-ei02.pdf
Note that the IP100 module is already build into the Imperial control panel.
Step 3: Run BabyWare installation program
Download the installation program from the Paradox Web site. Follow the instructions on your
screen to install BabyWare.
Step 4: Log Into BabyWare
Once you have installed BabyWare, a login dialog appears. The default user name is Admin. The
default password is 1234.
BabyWare
3
Quick Start