Publicité
Les langues disponibles
Les langues disponibles
1. Sound power level
2. Conformity marking
3. Month / Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an Authorised Service Centre.
IMPORTANT An example of the
Declaration of Conformity is provided
on the last pages of this manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Engine: drives the cutting means via
drive tube and angle transmission.
B. Transmission tube: The tube houses
the drive shaft which transmits rotary
motion to the angle transmission.
1. Drive tube.
2. Flexible drive tube
C. Angle transmission: final part of
the transmission tube that transmits
motion to the cutting means.
D. Cutting means: the element
designed to cut vegetation
1. Cutting line head: nylon
line cutting means.
2. 3 point, 4 point and 8 point
blades: metal disk cutting means.
3. Saw blade (if allowed): circular
metal disk cutting means with
peripheral cutting teeth.
E. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
1. Cutting line head.
2. Saw blade (if allowed)
F.
Front hand grip: semi-circular shaped,
it is used to handle the machine and
is equipped with a leg guard.
G. Rear hand grip: used to handle the
machine and equipped with the main
on/off/acceleration control buttons.
H. Leg guard: a safety guard that
prevents accidental contact with
the cutting means during use.
I.
Handle bar: "ox horn" shaped handle
bar transversely placed to the rod and
asymmetrically to it; used to control
the machine and equipped, on the
right hand side, with the main on/
off/acceleration control buttons.
J.
Display: information regarding the machine
operation and maintenance is displayed.
K. Connection point (of the harness): where
the harness is connected to the machine.
L. Harnessing: device made up of a
fabric belt which, placed over the
shoulders, helps to support the weight
of the machine during work:
1. double strap.
2. with back-pack power unit
M. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the "ASSEMBLY"
section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
EN - 6
Publicité
