Fitting Instructions - R&G LP0299BK Instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Page 8 of 23

Picture 21

•

To fit the R&G tail tidy, remove both seats from the bike using the key as shown in picture 1.

•

Remove the rear luggage rack plate by removing the 4 x bolts shown in picture 2 using a

10mm socket.

•

Using a 4mm hex key, remove the bolts shown in pictures 3 & 4

•

On both sides of the bike, remove the outer body panels by sliding the panels backwards to

disengage the plastic hooks as shown in picture 5.

•

Next, remove the 4 fairing bolts shown in pictures 6, 7 & 8 & 9 and remove each rear panel

separately from the bike.

•

You now have access to the subframe and tail unit fixing bolts. Before proceeding, disconnect

the tail unit wiring connection as shown in picture 10.

•

To remove the tail unit, use a 10mm socket or spanner to hold the 2 nuts arrowed in picture

11, while using a T30 torx to remove the 2 x bolts from the underside of the tail unit as shown

in picture 12. Note: you may unhook the seat lock cable from the plastic guide to aid access to

the nuts, remembering to replace before the seat is reattached.

•

While supporting the tail unit, remove the remaining torx bolt from the underside of the tail

unit, being careful to remove thread the wiring through the slot in the bike as shown in picture

13 as the unit is removed.

•

With tail unit removed. The plastic undertray must be lowered slightly away from the bike so

that 2 OEM spacers sandwiched between undertray and subframe may be replaced with the

included S0722 (item 4) counterparts.

•

Remove the two fairing bolts shown in picture 14 and carefully slide the undertray forwards

and down to lower this away from the subframe as shown in picture 15.

•

Remove the two spacers arrowed in picture 16 from above by sliding the spacers out and

replacing with S0722 (item 4) in the same orientation ensuring the small boss sits into the

undertray. Clip the tray back into place and replace the bolts removed in the previous step to

secure.

•

The OEM tail unit will need to be partially disassembled to re-use the wiring sub-loom for

indicators and licence plate light. To do this, use a Philips screwdriver to remove the screw

shown in picture 17 and remove the plastic panel.

Unit

Tel: +44 (0)

420 89007 Fax: +44 (0)