Fitting Instructions - R&G LP0208BK Instructions De Montage

Page | 5

FITTING INSTRUCTIONS


To fit the R&G tail tidy, remove the seat using the key and disconnect the three licence plate
illuminator/indicator connectors that are arrowed in picture 1 and shown in picture 2.

Remove the clip and cut the cable tie that bundle the wiring together.

Remove the four bolts that mount the underside of the OEM licence plate bracket to the bike, as shown in picture
3 and gently remove from the bike, feeding the wiring out in the process.

Take the licence plate bracket (item 4 – TB0178) and fit the R&G tail light (item 1 – LA0002) to the bracket, as
shown in pictures 4 & 5. Fit one length of heatshrink to the wires, tighten the nuts on the rear and use a small
amount of super glue to secure the light shroud in place, as shown in picture 5.

Take the cover plate (item 7 – TB0208 Cover) and fit the rubber bung (item 8 – RB0004) through the large hole
from either side, as shown in picture 6.

Offer the two assemblies together, with the cover plate positioned on top of the four mounting holes of the
licence plate bracket and fit the four M6 x 25mm long button head bolts (item 5) and four M6 washers (item 6)
through the licence plate bracket and then through the cover plate, as shown in picture 7. Ensure the rubber bung
is positioned so the internal recess faces downwards when mounted on the bike.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 13
Picture 15
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
Picture 14
Picture 16
info@rg-racing.com