Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Page 3 of 10
Picture 1
To install front indicators
•
Remove OEM fairings in order to access the rear of the OEM indicators, once
accessible, remove and disconnect them ensuring you label them
appropriately to aid re-installation.
Release or cut any cable ties which constrain the OEM indicator wiring.
•
To fit R&G mini-indicators (not included) or similar, pre-assemble the
•
components included as shown in COMPONENT PARTS DIAGRAM shown
above.
Place one of the indicator adaptor plates (item 1) onto the indicator with the
•
chamfered face towards the indicator lens, then place through the mounting
face of the bike as shown in Picture 1.
Clamp the indicator into position with the nut, repeat for the remaining
•
indicator on the other side.
To re-connect the indicators to the original wiring loom, use (item 2).
•
•
It is a good idea to check operation at this stage before re-installing the
fairings.
(If illumination fails, swap the bullet connections
note, dependant on the indicators you purchase, you may require resistors to
achieve the correct flash rate (these are available separately).
After testing, disconnect the connectors from both indicators.
•
Feed the indicator wiring through one of the nut/wiring covers (item 3) as
•
shown in COMPONENT PARTS DIAGRAM (it helps if a small amount of
liquid detergent is used) and position the nut cover over the nut (repeat the
above for the opposite indicator).
Fit a section of the heat-shrink (item 4) over the wires of each indicator so
•
the heat-shrink fits over the stem of the nut/wire cover and gently heat until
the heat-shrink contracts to the wiring and nut/wire cover as shown in (repeat
the above for the opposite indicator).
•
Feed the wiring as original and connect both indicators.
Refit all the original parts in the reverse order of removal.
•
Please test the indicators before riding.
•
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
FITTING PICTURES
FITTING INSTRUCTIONS
R&G
www.rg-racing.com
IA/IAS0031
Picture 2
around). Please
Email:
info@rg-racing.com
Publicité
Table des Matières
