Fitting Instructions - R&G LP0149BK Instructions De Montage

FITTING INSTRUCTIONS


To fit the R&G tail tidy, first remove the pillion seat using the key.

Remove the connector for the rear part of the wiring loom to the indicators and license plate
illuminator and unclip the plastic clips holding the wiring in place, as shown in picture 1.

Remove the four bolts that secure the license plate hanger in place, as arrowed in picture 2.

The license plate hanger should now come away from the bike whilst gently guiding the wiring
through the hole, as shown in picture 3.

With the OEM license plate hanger now on a workbench, remove the four screws and push rivet on
the underside of the hanger, as shown in picture 4.

Remove the plastic underside exposing the wiring, as shown in picture 5.

Disconnect the wiring connectors to the indicators, ensuring to mark them with the matching
connecters for re-fitting. Remove the two nuts on the ends of the indicator stalks and remove the
indicators from their housing and the license plate hanger, as shown in picture 6.

With the indicators removed, you should have what is shown in picture 7.

To re-use the OEM part of the loom with the R&G licence plate illuminator, the wiring needs to be
cut and fitted with two bullet connectors supplied with the Licence Plate Illuminator. To do this,
cut the wiring between the OEM licence plate illuminator and where it connects to the indicator
wiring, as shown by the yellow line in picture 8 and fit the connectors.

Take the R&G Licence Plate Bracket (item 1 – TB0146 Part 1) and fit the R&G license plate
illuminator (item 8), as shown in picture 9. Use a small amount of superglue to stick the light
shroud in position. Fit one length of heatshrink to the wires and tighten the nuts on the rear.

Fit the rubber grommet (item 9) through the large 20mm diameter hole on the licence plate bracket,
ensuring the deep recess is on the underside, as shown in picture 10.

Loop one of the cable ties through the two slots near where the rubber grommet is fitted, ensuring
the ends are on the underside of the licence plate bracket, as shown in picture 11. Do not tighten at
this stage.

The R&G licence plate bracket can now be offered up to the underside of the bike. Take the four
spacers (item 5 – 5.3mm long) and locate into the four holes on the top side of the license plate
bracket (surface which sits against the undertray of the bike when fitted) (a dab of superglue on
each spacer will help to hold the spacers in place whilst fitting. Slide the two tabs at the front into
the two slots on the plastic undertray, then fit the four M8 x 20mm long button head bolts (item 2)
through the four spacers and up into the rear subframe. Locate one M8 washer (item 4) and one M8
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 15
R&G Racing
www.rg-racing.com Email: info@rg-racing.com