Fitting Instructions - R&G ECS0148 Mode D'emploi

Page 5 of 9
Picture 13
Picture 15

FITTING INSTRUCTIONS

• Make sure the engine is cold before proceeding with the fitting of the R&G engine
case slider.
• Remove the 2 tank cover panel bolts from both sides of the bike arrowed in
picture 1. Pull the panel up gently until the locating pins release.
• Remove the bolt shown in picture 2 from the bottom of the nose.
• Remove the bolts arrowed in pictures 3 and 4 from underneath the lower
fairings.
• Remove the radiator shroud bolt shown in picture 5 from the left side.
• Remove the rear fairing bolt from the left side of the bike as shown in picture 6.
• Remove the 3 bolts holding the lower fairing to the upper fairing arrowed in
picture 7 from left side of the bike. The lower fairing can be removed at this
stage by gently separating it from the radiator shroud.
• Remove the bolts shown in pictures 8 and 9 from the left side.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 14
Picture 16
R&G
www.rg-racing.com Email:
ECS0148
info@rg-racing.com